Home › Vehicle Interior › SEAT › REAR SEAT RECLINING CONTROL CABLE

REAR SEAT RECLINING CONTROL CABLE > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing.
for Separate Type Yaw Rate Sensor: (Click here)
for Built-in Type Yaw Rate Sensor: (Click here)

NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (Click here).



2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



3. REMOVE REAR SEAT CUSHION ASSEMBLY


  1. Disengage the hook of the seat cushion from the vehicle body as shown in the illustration.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.




      B279202E01
    1. Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
      Standard Measurement 
      a
      100 mm (3.94 in.) or less

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.



4. REMOVE REAR SEAT CUSHION LOCK HOOK


    B279203
  1. Disengage the claw and remove the rear seat cushion lock hook.

    NOTICE:
    Rear seat cushion lock hooks must not be reused.

    HINT:
    Use the same procedure for the RH side and the LH side.



5. REMOVE INNER LUGGAGE COMPARTMENT TRIM PAD


    B279201
  1. Remove the inner luggage compartment trim pad.



6. REMOVE REAR SEATBACK ASSEMBLY LH


    B279209E01
  1. Disengage the 2 fasteners as shown in the illustration.
    Text in Illustration 
    *1
    Fastener



    B279211
  1. Remove the 2 bolts and rear seatback assembly LH.

    NOTICE:
    Be careful not to damage the vehicle body.



7. REMOVE REAR SEATBACK ASSEMBLY RH


    B279206E01
  1. Disengage the 3 fasteners as shown in the illustration.
    Text in Illustration 
    *1
    Fastener



    B279208
  1. Remove the 2 bolts and rear seatback assembly RH.

    NOTICE:
    Be careful not to damage the vehicle body.



8. REMOVE REAR SIDE SEATBACK ASSEMBLY LH
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide.

  1. Disconnect the connector.



    B285010
  1. Remove the 2 bolts.

  1. Disengage the hook and remove the rear side seatback assembly LH.



9. REMOVE REAR SIDE SEATBACK ASSEMBLY RH
  1. Disconnect the rear seat outer belt from the rear seat shoulder belt guide.

  1. Disconnect the connector.



    B285009
  1. Remove the 2 bolts.

  1. Disengage the hook and remove the rear side seatback assembly RH.



10. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP LH
  1. Disconnect the rear door opening trim weatherstrip LH.



11. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP RH
  1. Disconnect the rear door opening trim weatherstrip RH.



12. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for LH Side)


    B271094
  1. Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.



13. DISCONNECT REAR SEAT OUTER BELT ASSEMBLY (for RH Side)


    B271092
  1. Remove the bolt and disconnect the floor anchor of the rear seat outer belt assembly.



14. REMOVE CHILD RESTRAINT SEAT ANCHOR BRACKET SUB-ASSEMBLY LH


    B279428
  1. Remove the 2 nuts and child restraint seat anchor bracket sub-assembly LH.



15. DISCONNECT REAR SEAT INNER WITH CENTER BELT ASSEMBLY LH


    B271090
  1. Remove the bolt and disconnect the floor anchor of the rear seat inner with center belt assembly LH.



16. REMOVE ROOF SIDE INNER GARNISH LH


    B278991
  1. Disengage the 5 clips.

  1. Disengage the guide and remove the roof side inner garnish LH.



17. REMOVE ROOF SIDE INNER GARNISH RH

HINT:
Use the same procedure as for the LH side .



18. REMOVE CENTER STOP LIGHT SET


    E226678E01
  1. Slide the center stop light set in the order and directions shown by the arrows in the illustration while pushing it towards the rear of the vehicle to disengage the 4 claws.



    E231297
  1. Turn the center stop light set 180 degrees as shown by the arrow in the illustration.

    HINT:
    This makes it easier to disconnect the connector.

  1. Disconnect the connector and remove the center stop light set.



19. REMOVE CHILD RESTRAINT SEAT TETHER ANCHOR COVER


    B271100
  1. Using a moulding remover, disengage the 2 claws and 2 guides to remove the child restraint seat tether anchor cover.

    HINT:
    Use the same procedure for the other 2 child restraint seat tether anchor covers.



20. REMOVE REAR SEAT SHOULDER BELT COVER


    B271099
  1. Using a moulding remover, disengage the 2 claws and 4 guides and remove the rear seat shoulder belt cover.

    HINT:
    Use the same procedure for the other 2 rear seat shoulder belt covers.



21. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY


    B279423E01
  1. Using pliers, disengage the 3 clips from inside the luggage compartment as shown in the illustration.
    Text in Illustration 
    *1
    Protective Tape

    HINT:
    Tape the tip of the pliers before use.

  1. Disengage the 5 guides.

  1. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly then remove the package tray trim panel assembly.



22. REMOVE ROOM PARTITION BOARD LH


    B279212
  1. Disengage the guide, 2 claws and 4 clips, and remove the room partition board LH.



23. REMOVE ROOM PARTITION BOARD RH


    B279213
  1. Using a clip remover, remove the 2 clips.

  1. Disengage the 5 clips and remove the room partition board RH.



24. REMOVE REAR SEATBACK LOCK ASSEMBLY LH (REAR SEAT LOCK CONTROL CABLE LH)


    B279214
  1. Disengage the hook as shown in the illustration.



    B287904
  1. Remove the 2 nuts and rear seatback lock assembly LH (rear seat lock control cable LH).



25. REMOVE REAR SEATBACK LOCK ASSEMBLY RH (REAR SEAT LOCK CONTROL CABLE RH)

HINT:
Use the same procedure as for the LH side.