SOLAR SENSOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Radio and Display Type with Intuitive Parking Assist System) |
| 3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (for Navigation Receiver Type) |
| 4. REMOVE REAR CONSOLE BOX ASSEMBLY |
| 5. REMOVE BOX BOTTOM MAT |
![]() |
Remove the box bottom mat.
| 6. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY |
![]() |
Remove the 2 screws <C> or <D>.
![]() |
Disengage the 4 clips and guide as shown in the illustration.
Disconnect each connector to remove the upper console panel sub-assembly.
| 7. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL ASSEMBLY |
![]() |
Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.
![]() |
Using a moulding remover, disengage the 2 claws and 2 clips as shown in the illustration.
![]() |
Disengage the 3 claws and 2 clips as shown in the illustration.
![]() |
Disengage the clamp.
Disconnect the connector to remove the center instrument cluster finish panel assembly.
| 8. REMOVE NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY |
![]() |
Pull the No. 2 instrument panel register assembly in the direction indicated by the arrow to disengage the 6 clips to remove the No. 2 instrument panel register assembly.
| 9. REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Radio Receiver Type) |
![]() |
Apply protective tape to the area shown in the illustration.
| *1 | Protective Tape |
![]() |
Remove the 4 bolts.
![]() |
Pull the radio receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.
Disconnect each connector and remove the radio receiver assembly with air conditioning control assembly.
| 10. REMOVE RADIO RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Radio and Display Type) |
![]() |
Apply protective tape to the area shown in the illustration.
| *1 | Protective Tape |
![]() |
Remove the 4 bolts.
![]() |
Pull the radio receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.
Disconnect each connector and remove the radio receiver assembly with air conditioning control assembly.
| 11. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH AIR CONDITIONING CONTROL ASSEMBLY (for Navigation Receiver Type) |
![]() |
Apply protective tape to the area shown in the illustration.
| *1 | Protective Tape |
![]() |
Remove the 4 bolts.
![]() |
Pull the navigation receiver assembly with air conditioning control assembly toward the rear of the vehicle and disengage the 8 clips.
Disconnect each connector and remove the navigation receiver assembly with air conditioning control assembly.
| 12. REMOVE NO. 1 SPEAKER OPENING COVER ASSEMBLY |
![]() |
Disengage the 8 clips as shown in the illustration.
Disconnect the connector to remove the No. 1 speaker opening cover assembly.
| 13. REMOVE SOLAR SENSOR |
![]() |
Disengage the 2 claws and remove the solar sensor.