Home › Vehicle Exterior › LIGHTING (EXT) › LIGHTING SYSTEM

LIGHTING SYSTEM > Turn Signal Switch Circuit

for Preparation Click here


DESCRIPTION

The combination meter receives the turn signal switch information and controls the turn signal lights.

WIRING DIAGRAM


E224250E01


INSPECTION PROCEDURE

1.READ VALUE USING TECHSTREAM
  1. Connect the Techstream to the DLC3.

  1. Turn the ignition switch to ON.

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Data List.

  1. Read the display on the Techstream.

    Combination Meter 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Turn Signal Switch (Right)
    Turn signal switch (Right) signal/ON or OFF
    ON: Turn signal switch (Right) on
    OFF: Turn signal switch (Right) off
    -
    Turn Signal Switch (Left)
    Turn signal switch (Left) signal/ON or OFF
    ON: Turn signal switch (Left) on
    OFF: Turn signal switch (Left) off
    -

    OK:
    Normal conditions listed above are displayed.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT HEADLIGHT DIMMER SWITCH ASSEMBLY


    E223779E07
  1. Remove the headlight dimmer switch assembly (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    12 (TR) - 15 (EL)
    Turn signal switch in neutral position
    10 kΩ or higher
    11 (TL) - 15 (EL)
    Turn signal switch in neutral position
    10 kΩ or higher
    12 (TR) - 15 (EL)
    Turn signal switch in right turn position
    Below 1 Ω
    11 (TL) - 15 (EL)
    Turn signal switch in left turn position
    Below 1 Ω

    Text in Illustration 
    *a
    Component without harness connected
    (Headlight Dimmer Switch Assembly)



NG
REPLACE HEADLIGHT DIMMER SWITCH ASSEMBLY (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (HEADLIGHT DIMMER SWITCH ASSEMBLY - COMBINATION METER ASSEMBLY)
  1. Disconnect the I17 combination meter assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    I25-12 (TR) - I17-3 (ER)
    Always
    Below 1 Ω
    I25-11 (TL) - I17-4 (EL)
    Always
    Below 1 Ω
    I25-15 (EL) - Body ground
    Always
    Below 1 Ω
    I17-3 (ER) - Body ground
    Always
    10 kΩ or higher
    I17-4 (EL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)