NAVIGATION SYSTEM (for Navigation Receiver Type) > PRECAUTION |
| 1.IGNITION SWITCH EXPRESSIONS |
The type of ignition switch used on this model differs according to the specifications of the vehicles. The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
| Ignition Switch off | LOCK | Off |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | Start |
| 2.PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL |
| System Name | See Procedure |
| Parking Assist Monitor System |
Click here
|
| 3.PRECAUTIONS FOR NAVIGATION RECEIVER ASSEMBLY |
A Hard Disk Drive (HDD) is built into the navigation receiver assembly to store map and other data, and is used for the navigation system. Therefore, care must be taken for the following points when handling:

When it is necessary to replace the navigation ECU sub-assembly, be sure to replace it with a new one.
Do not apply any vibration or shock to the navigation receiver assembly.
Do not remove the navigation receiver assembly if there is a risk that condensation may occur.
Take measures to prevent static electricity.
Keep the navigation receiver assembly away from magnets or magnetized items.
| 4.PRECAUTIONS FOR HARD DISK DRIVE (HDD) |
Map and other data for the navigation system is stored on the Hard Disk Drive (HDD). Make sure to follow the following instructions when replacing the HDD:
The HDD must only be replaced with a new one. Do not attempt to install a used HDD from another vehicle.
![]() |
Do not touch the HDD cover.
Do not apply any vibration or shock to the HDD.
Do not remove the HDD if there is a risk that condensation may occur.
Take measures to prevent static electricity.
Keep the HDD away from magnets or magnetized items.
Inspect after HDD replacement.