Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › THROTTLE BODY
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074396 THROTTLE BODY A

2GR-FE ENGINE CONTROL  THROTTLE BODY  INSTALLATION  


PROCEDURE

Hide 22030 1.INSTALL THROTTLE WITH MOTOR BODY ASSEMBLY

a.
A133820

Install a new gasket to the intake air surge tank assembly.


b.

Install the throttle with motor body assembly and wire harness clamp stay to the intake air surge tank assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the throttle body connector and wire harness clamp.


d.

Connect the 2 water by-pass hoses to the throttle with motor body assembly.


Hide 17735 2.INSTALL AIR CLEANER CAP SUB-ASSEMBLY

a.

Connect the air cleaner cap sub-assembly to the throttle with motor body assembly with the hose clamp.


b.
A276676
0.521,0.396 0.719,0.719 0.198,0.323 10 false *a
*a Hinge


Connect the 2 hinges of the air cleaner cap subassembly.


c.

Install the air cleaner cap with hose to the air cleaner case with the 2 clamps.


d.

Connect the wire harness clamp and mass air flow meter connector.


e.

Connect the 3 hoses.


f.

Connect the ventilation hose.


g.

Connect the mass air flow meter connector and wire harness clamp.


Hide 11209 5.INSTALL V-BANK COVER SUB-ASSEMBLY

Hide 6.PERFORM INITIALIZATION

NOTICE:
·

Be sure to perform this procedure after reassembling the throttle with motor body assembly or removing and reinstalling any throttle body component.

·

Perform the following procedure after replacing the throttle with motor body assembly or any throttle body components. The following procedure should also be performed if the throttle body is cleaned.



a.

Turn the ignition switch to ON without operating the accelerator pedal.

NOTICE:

If the accelerator pedal is operated, perform the above steps again.



b.

Connect the intelligent tester to the DLC3 and clear the DTCs.

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>DTC CHECK / CLEAR


c.

Perform the "Inspection After Repair".

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION


d.

Start the engine and check that the MIL is not illuminated. After the engine is warmed up, check that the idle speed is within the specified range when the A/C is switched off.

Standard:
Condition Engine Idle Speed
A/C switched off 600 to 700 rpm


NOTICE:
·

Be sure to perform this step with all accessories off.

·

Make sure that the shift lever is in neutral.




e.

Enter the following menus: Powertrain / Engine / Data List / Throttle Sensor Position. Fully depress the accelerator pedal and check that the value is 60% or more.

Powertrain > Engine > Data List
Tester Display
Throttle Sensor Position
50003 234 12

f.

Perform a road test and confirm that there are no abnormalities.