Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › THROTTLE BODY
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074396 THROTTLE BODY A

2GR-FE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


PROCEDURE

Hide 11209 2.REMOVE V-BANK COVER SUB-ASSEMBLY

Hide 17735 3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY

a.
A254996

Disconnect the mass air flow meter connector and wire harness clamp.


b.
A254997

Disconnect the 3 hoses.


c.

Disconnect the ventilation hose.


d.
A276659

Loosen the hose clamp and separate the air cleaner cap sub-assembly from the throttle with motor body assembly.


e.

Release the 2 clamps and remove the air cleaner cap with hose.


Hide 22030 4.REMOVE THROTTLE WITH MOTOR BODY ASSEMBLY

a.
A331956

Disconnect the 2 water by-pass hoses from the throttle with motor body assembly.


b.
A201970

Disconnect the throttle body connector and wire harness clamp.


c.

Remove the 4 bolts, throttle with motor body assembly and wire harness clamp stay.


d.

Remove the gasket from the intake air surge tank assembly.