Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › MASS AIR FLOW METER
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074400 MASS AIR FLOW METER G

2GR-FE ENGINE CONTROL  MASS AIR FLOW METER  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

Perform the MAF meter inspection according to the following procedure.

·

Only replace the MAF meter when the MAF value in the Data List (with the engine stopped) is not within the normal operating range or there is foreign matter on the MAF meter platinum hot wire (heater).



PROCEDURE

Hide 22204 1.INSPECT MASS AIR FLOW METER

a.

Read the values using the intelligent tester (MAF).

NOTICE:
·

Perform the inspection with the vehicle indoors and on a level surface.

·

Perform the inspection of the MAF meter while it is installed to the air cleaner case (installed to the vehicle).

·

During the test, do not use an exhaust air duct on the exhaust pipe.



i.

Connect the intelligent tester to the DLC3.


ii.

Turn the ignition switch to ON (do not start the engine).


iii.

Enter the following menus: Powertrain / Engine / Data List / Primary / MAF.

Powertrain > Engine > Data List
Tester Display
MAF
50003 234 3

iv.

Wait for 30 seconds, and read the values on the intelligent tester.

Standard Condition:
Tester Display Condition Specified Condition
MAF
·

Engine not running

·

30 seconds after ignition switch turned ON


0.51 g/sec. or less


If the result is not as specified, replace the MAF meter.

If the result is within the specified range, remove and inspect the MAF meter.

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>MASS AIR FLOW METER>INSPECTION