Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ENGINE COOLANT TEMPERATURE SENSOR
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074404 ENGINE COOLANT TEMPERATURE SENSOR A

2GR-FE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  INSTALLATION  


PROCEDURE

Hide 89422 1.INSTALL ENGINE COOLANT TEMPERATURE SENSOR

a.

Install a new gasket onto the engine coolant temperature sensor.


b.

Install the engine coolant temperature sensor.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

Use the torque value compensation formula to calculate the torque value for use when a torque wrench is combined with a tool such as a ball joint lock nut wrench.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


HINT:

Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.

Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>SFI SYSTEM>INITIALIZATION



c.

Connect the engine coolant temperature sensor connector.


d.

Connect the 2 engine wire clamps.


Hide 53295E 4.INSTALL COOL AIR INTAKE DUCT SEAL

Hide 11209 5.INSTALL V-BANK COVER SUB-ASSEMBLY