Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › KNOCK SENSOR
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074405 KNOCK SENSOR A

2GR-FE ENGINE CONTROL  KNOCK SENSOR  INSTALLATION  


PROCEDURE

Hide 89615 1.INSTALL KNOCK CONTROL SENSOR

a.
A129616
0.51,1.427 0.677,1.688 0.167,0.26 10 *c 1.719,0.052 1.979,0.385 0.26,0.333 10 *a 3.042,0.448 3.208,0.594 0.167,0.146 10 5° 3.052,1.573 3.219,1.719 0.167,0.146 10 5° 3.031,0.677 3.281,0.823 0.25,0.146 10 10° 3.021,1.354 3.271,1.5 0.25,0.146 10 10° 1.729,1 2.01,1.313 0.281,0.313 10 *b
*a for Bank 1
*b for Bank 2
*c Front of Vehicle


Install the 2 knock control sensors with the 2 bolts as shown in the illustration.

Torque:
20 N*m (204 kgf*cm, 15 ft.*lbf)

NOTICE:

Make sure that each knock control sensor is in the correct position.



b.

Connect the 2 knock control sensor connectors.