Home › Engine / Hybrid System › 2GR-FE ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL
RM2030EQ _51 Engine / Hybrid System _014635 2GR-FE ENGINE MECHANICAL _0074415 REAR CRANKSHAFT OIL SEAL A

2GR-FE ENGINE MECHANICAL  REAR CRANKSHAFT OIL SEAL  REMOVAL  


PROCEDURE

Hide 32101 2.REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY

a.
A205853
0.202,1.106 0.493,1.265 0.291,0.159 10 SST 1.828,1.077 0.609,1.186 0.609,1.186 1.455,0.942 false

Using SST, hold the crankshaft pulley.

SST
09213-70011  (09213-70020)
09330-00021  


b.
A132243

Remove the 8 bolts, front drive plate spacer, drive plate and ring gear sub-assembly and rear drive plate spacer.


Hide 11381A 3.REMOVE ENGINE REAR OIL SEAL

a.
A132244
1.927,1 1.927,1.583 true 0.375,0.594 0.51,0.594 0.51,0.594 0.792,1.49 true 1.865,1.635 2.208,1.885 0.344,0.25 10 false *1 0.177,0.5 0.49,0.719 0.313,0.219 10 false *a
*1 Protective Tape
*a Cut Position


Using a knife, cut off the engine rear oil seal lip.


b.

Using a screwdriver, pry out the engine rear oil seal.

NOTICE:

Be careful not to damage the crankshaft.


HINT:

Tape the screwdriver tip before use.