Home › Engine / Hybrid System › 2GR-FE FUEL › FUEL PUMP ECU › 2012.02–2013.07
RM2030EQ _51 Engine / Hybrid System _014636 2GR-FE FUEL _0074424 FUEL PUMP ECU A

2GR-FE FUEL  FUEL PUMP ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 64711 3.REMOVE LUGGAGE COMPARTMENT FLOOR MAT

Hide 58387 4.REMOVE REAR FLOOR FINISH PLATE

Hide 64725D 5.REMOVE NO. 1 LUGGAGE COMPARTMENT TRIM HOOK

Hide 64722 6.REMOVE LUGGAGE COMPARTMENT INNER TRIM COVER LH

Hide 89570A 7.REMOVE FUEL PUMP CONTROL ECU ASSEMBLY

a.
A254952

Disconnect the connector and clamp from the fuel pump control ECU assembly.


b.

Remove the 2 nuts and fuel pump control ECU assembly.

NOTICE:

Do not reuse the fuel pump control ECU if it has been dropped or subjected to a severe impact.


HINT:

If a malfunction such as pump lock occurs and the fuel pump is damaged, excessive current may be continuously applied to the fuel pump control ECU, damaging its internal parts. Make sure to replace the fuel pump control ECU at the same time when replacing the fuel pump.