Home › Engine / Hybrid System › 2GR-FE EMISSION CONTROL › EMISSION CONTROL SYSTEM
RM2030EQ _51 Engine / Hybrid System _014637 2GR-FE EMISSION CONTROL _0074427 EMISSION CONTROL SYSTEM G

2GR-FE EMISSION CONTROL  EMISSION CONTROL SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT FUEL CUT RPM

a.

Start and warm up the engine.


b.

Increase the engine speed to approximately 3000 rpm.


c.
A192826C01
1.552,0.302 1.906,0.302 1.906,0.302 2.708,1.438 false 1.396,0.229 1.604,0.417 0.208,0.188 10 true *1
*1 Sound Scope


Use a sound scope to check for injector operating sounds.


d.

When the accelerator pedal is released, check that injector operating sounds stop momentarily and then resume.

Standard:
Item Specified Condition
Fuel cut off rpm 2500 rpm or higher
Fuel injection restart rpm 1400 rpm


If the result is not as specified, check the injectors, wiring and ECM.


Hide 2.VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS

a.

Inspect the hoses and gaskets for scratches, cracks or air/oil leaks from the connecting parts.

HINT:

If the hoses or gaskets are damaged or some of the connections are loose, they may cause an engine stall or malfunction.



Hide 3.INSPECT EVAPORATIVE EMISSION CONTROL SYSTEM

a.

Connect the intelligent tester to the DLC3.


b.
A255849

Disconnect the fuel vapor feed hose from the purge VSV.


c.

Start the engine.


d.

Enter the following menus: Powertrain / Engine / Active Test / Activate the VSV for Evap Control.

Powertrain > Engine > Active Test
Tester Display
Activate the VSV for Evap Control
50004 234 6

e.

Check that vacuum occurs at the purge VSV port.


f.

If vacuum does not occur, check the following items:

·

Purge VSV (for canister purge)

·

Clogs in the fuel vapor feed hose connecting the intake air surge tank and purge VSV

·


g.

Exit Active Test mode and reconnect the fuel vapor feed hose.


h.

Enter the following menus: Powertrain / Engine / Data List / EVAP Purge VSV.

Powertrain > Engine > Data List
Tester Display
EVAP Purge VSV
50003 234 217

i.

Warm up the engine and drive the vehicle.


j.

Confirm that the purge VSV opens.

If the result is not as specified, replace the purge VSV, wire harness or ECM.