Home › Engine / Hybrid System › 2GR-FE LUBRICATION › LUBRICATION SYSTEM
RM2030EQ _51 Engine / Hybrid System _014640 2GR-FE LUBRICATION _0074450 LUBRICATION SYSTEM G

2GR-FE LUBRICATION  LUBRICATION SYSTEM  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 1.INSPECT ENGINE OIL LEVEL

a.

Warm up the engine, stop it and wait 5 minutes. The oil level should be between the engine oil level dipstick low level mark and full level mark.

If the engine oil level is low, check for leakage and add oil up to the full level mark.

NOTICE:

Do not add engine oil to above the full level mark.



Hide 2.INSPECT ENGINE OIL QUALITY

a.

Check the engine oil for deterioration, water contamination, discoloring or thinning.

If the condition is visibly poor, replace the engine oil and engine oil filter.


Hide 3.INSPECT OIL PRESSURE

a.

b.
A256238
2.583,1.75 2.052,1.75 false 1.885,1.667 2.094,1.844 0.208,0.177 10 false *1
*1 Oil Pressure Gauge


Install the oil pressure gauge with the adapter.


c.

Warm up the engine.


d.

Check the oil pressure.

Standard Oil Pressure:
Engine Condition Oil Pressure
Idle 30 kPa (0.3 kgf/cm2, 4.4 psi) or more
3000 rpm 200 kPa (2.0 kgf/cm2, 29 psi) or more


If the oil pressure is not as specified, check the oil pump.

Click hereEngine / Hybrid System>2GR-FE LUBRICATION>OIL PUMP>INSPECTION


e.

Remove the oil pressure gauge with the adapter.