Do not replace the spiral cable with the battery connected and the ignition switch on.
Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch on.
Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.
Do not remove the steering sensor from the spiral cable.
1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
45130
2.REMOVE HORN BUTTON ASSEMBLY
45100
3.REMOVE STEERING WHEEL ASSEMBLY
84250A
4.REMOVE STEERING PAD SWITCH ASSEMBLY
84610F
5.REMOVE SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
Remove the 2 screws.
Disengage the 4 pins and remove the 2 shift paddle switches (transmission shift switch assembly).
84523
6.REMOVE NO. 1 SWITCH WIRE
Disengage the 5 guides to remove the shift paddle switch (transmission shift switch assembly) with No. 1 switch wire from the steering wheel assembly.
| *1 | Clamp |
Remove the 2 clamps.
Disconnect the 2 connectors to remove the 2 shift paddle switches (transmission shift switch assembly) from the No. 1 switch wire.