Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB
RM2030EQ _52 Drivetrain _014645 AXLE AND DIFFERENTIAL _0074483 FRONT AXLE HUB G

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 2.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 3.REMOVE FRONT DISC

Hide 4.INSPECT FRONT AXLE HUB BEARING LOOSENESS

a.
C238966

Using a dial indicator, check for looseness near the center of the front axle hub.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the front speed sensor.



If the looseness exceeds the maximum, replace the front axle hub bearing.


Hide 5.INSPECT FRONT AXLE HUB RUNOUT

a.
C238967

Using a dial indicator, check for runout on the surface of the front axle hub outside the hub bolts.

Maximum runout:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the front speed sensor.



If the runout exceeds the maximum, replace the front axle hub.


Hide 43512 6.INSTALL FRONT DISC

Hide 7.INSTALL FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 8.INSTALL FRONT WHEEL

Torque:
103 N*m (1049 kgf*cm, 76 ft.*lbf)