Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE REAR WHEEL
2.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY
42491
3.REMOVE PARKING BRAKE SHOE ADJUSTING HOLE PLUG
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
42431
4.REMOVE REAR DISC
Click hereBrake>BRAKE (REAR)>REAR BRAKE>REMOVAL
89516D
5.DISCONNECT SKID CONTROL SENSOR WIRE
42450B
6.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY
Remove the 4 bolts and the rear axle hub and bearing assembly.
Use wire or an equivalent tool to keep the parking brake assembly from hanging down by the parking brake cable assembly.