Home › Suspension › FRONT SUSPENSION › FRONT LOWER BALL JOINT
RM2030EQ _53 Suspension _014647 FRONT SUSPENSION _0074492 FRONT LOWER BALL JOINT A

FRONT SUSPENSION  FRONT LOWER BALL JOINT  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT AXLE ASSEMBLY

Hide 43340A 2.REMOVE FRONT LOWER BALL JOINT ASSEMBLY

a.

Secure the front axle assembly in a vise using aluminum plates.

NOTICE:

When using a vise, do not overtighten it.



b.
C207073

Remove the cotter pin and nut.


c.
C165932
1.97,2.895 2.339,3.047 0.369,0.152 10 1 mm 0.48,2.609 0.794,2.765 0.314,0.156 10 SST 0.587,0.211 0.901,0.368 0.314,0.156 10 SST 0.847,2.689 2.027,2.689 2.027,2.689 2.027,2.57 false 1.855,2.689 1.855,2.57 false 0.935,0.284 1.721,0.284 1.721,0.284 1.721,1.009 false 1.576,1.043 1.576,0.284 false

Install SST to the front lower ball joint assembly as shown in the illustration.

SST
09960-20010  (09961-02050, 09961-02050)

NOTICE:

Check that the clearance measurement between SST and the front axle assembly is 1 mm (0.0394 in.).



d.
C238957
1.896,1.281 2.167,1.667 2.167,1.667 2.458,1.667 true 1,2.156 0.531,2.156 false 2.219,3.333 2.396,3.552 0.177,0.219 10 false A 2.219,0.292 2.438,0.479 0.219,0.188 10 false *a 2.167,0.656 2.333,0.865 0.167,0.208 10 false *a 2.479,1.594 2.677,1.802 0.198,0.208 10 false *b 2.219,3.615 2.365,3.813 0.146,0.198 10 false B 0.25,2.083 0.625,2.292 0.375,0.208 10 false SST
*a Apply grease
*b Place wrench here


Using SST, remove the front lower ball joint assembly from the front axle assembly as shown in the illustration.

SST
09960-20010  (09961-02010, 09961-02050, 09961-02050)

CAUTION:

Apply grease to the threads and end of the SST bolt.


NOTICE:
·

Install SST so that A and B are parallel.

·

Be sure to place a wrench on the part indicated in the illustration.

·

Do not damage the front lower ball joint dust cover.