Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
1.REMOVE REAR SIDE SEATBACK ASSEMBLY
2.REMOVE REAR WHEEL
48840A
3.SEPARATE REAR STABILIZER LINK ASSEMBLY
Remove the nut and separate the rear stabilizer link assembly from the rear shock absorber assembly.
If the ball joint turns together with the nut, use a hexagon wrench to hold the stud.
47319F
4.SEPARATE REAR FLEXIBLE HOSE
Remove the bolt and separate the rear flexible hose from the rear shock absorber assembly.
89516D
5.SEPARATE SKID CONTROL SENSOR WIRE
Remove the bolt and separate the skid control sensor wire from the rear shock absorber assembly.
48753C
6.REMOVE REAR NO. 1 SUSPENSION SUPPORT COVER
Using a screwdriver, disengage the 4 claws and remove the rear No. 1 suspension support cover.
7.REMOVE REAR SHOCK ABSORBER WITH COIL SPRING
| *1 | Jack |
| *2 | Wooden Block |
Support the rear axle carrier sub-assembly with a jack using a wooden block.
Support the rear axle carrier sub-assembly until reinstallation of the rear shock absorber with coil spring is complete.
Loosen the rear support to rear shock absorber nut of the rear shock absorber assembly.
Do not remove the rear support to rear shock absorber nut.
Loosen the nut only when the rear shock absorber with coil spring needs to be disassembled.
Remove the 2 bolts and 2 nuts, and separate the rear shock absorber with coil spring from the rear axle carrier sub-assembly.
When removing the nuts, keep the bolts from rotating.
Remove the 3 nuts and rear shock absorber with coil spring.
Make sure that the skid control sensor wire and rear flexible hose are disconnected from the rear shock absorber with coil spring.
48760C
8.REMOVE REAR SUPPORT TO REAR SHOCK ABSORBER NUT
Secure SST in a vise.
| *a | Correct |
| *b | Incorrect |
Attach the arms of SST to the diameter of the rear coil spring.
Make sure that the rear coil spring is installed so that the distance between the upper and lower arms of SST is at the maximum.
Make sure that the claws of the arms are securely attached.
Using SST, compress the rear coil spring.
If the rear coil spring bends during compression, immediately stop compression and reinstall SST.
Do not excessively compress the rear coil spring so that the coils contact each other.
Do not use an impact wrench. It will damage SST.
Confirm that the rear coil spring becomes free and remove the rear support to rear shock absorber nut.
Do not remove the rear support to rear shock absorber nut when the rear coil spring is not free.
48760D
9.REMOVE REAR SUPPORT TO REAR SHOCK ABSORBER COLLAR
48760B
10.REMOVE REAR SUSPENSION SUPPORT ASSEMBLY
48231B
11.REMOVE REAR COIL SPRING
48341B
12.REMOVE REAR NO. 1 SPRING BUMPER
48258C
13.REMOVE REAR LOWER COIL SPRING INSULATOR
48540
14.REMOVE REAR SHOCK ABSORBER ASSEMBLY