Home › Suspension › TIRE / WHEEL › TIRE AND WHEEL SYSTEM › 2012.02–2013.07
RM2030EQ _53 Suspension _014649 TIRE / WHEEL _0074502 TIRE AND WHEEL SYSTEM G

TIRE / WHEEL  TIRE AND WHEEL SYSTEM  INSPECTION  


PROCEDURE

Hide 1.INSPECT TIRES

a.

Check the tires for wear and proper inflation pressure.

Cold Tire Inflation Pressure:
for RHD
Tire Size Front Rear
215/60R16 95V
215/55R17 94V
240 kPa (2.4 kgf/cm2, 35 psi)

for LHD
Tire Size Front Rear
215/60R16 95V 210 kPa (2.1 kgf/cm2, 30 psi)
215/55R17 93V 220 kPa (2.2 kgf/cm2, 32 psi)



b.
C137874

Using a dial indicator, check the runout of the tires.

Maximum tire runout:

1.4 mm (0.0551 in.)



Hide 2. ROTATE TIRES

a.
C163157
0.292,0.198 0.448,0.396 0.156,0.198 10 .
V100135

Front


Rotate the tires as shown in the illustration.


Hide 3.INSPECT AND ADJUST WHEEL BALANCE

a.

Inspect and adjust the off-the-car balance.

i.

Steel wheel:

Maximum imbalance:

8.0 g (0.0176 lb)



ii.
C144018
2.052,3.667 2.281,3.823 0.229,0.156 10 (A)

Others (Non-steel wheel):

Maximum imbalance:

8.0 g (0.0176 lb)


NOTICE:
·

Use a cleaning detergent to remove dirt, oil and water from the surface where the balance weight is to be adhered.

·

Do not touch the adhesive surface of the tape.

·

Adhere a sticking type balance weight to the flat surface (A) shown in the illustration.

Width (A):

25 mm (0.984 in.)


·

Push the balance weight securely with your finger to adhere it to the desired position.

·

Do not reuse balance weights.



HINT:

The inner side balance weight should be installed by clipping it to the rim.