Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › ULTRASONIC SENSOR(for Rear Side)
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0074565 ULTRASONIC SENSOR(for Rear Side) A

PARK ASSIST / MONITORING  ULTRASONIC SENSOR(for Rear Side)  INSTALLATION  


PROCEDURE

Hide 89348A 1.INSTALL NO. 2 ULTRASONIC SENSOR RETAINER

a.
E247790C01
2.135,0.583 2.531,0.281 false 0.969,0.479 0.615,0.271 false 2.573,0.167 2.729,0.313 0.156,0.146 10 false *b 0.417,0.177 0.573,0.323 0.156,0.146 10 false *a
*a Keyhole
*b Snap


Engage the 2 claws to install the No. 2 ultrasonic sensor retainer to the rear bumper assembly.

NOTICE:
·

Do not damage the front bumper with the protrusion when installing the retainer.

·

Securely install the No. 1 ultrasonic sensor retainer so that there are no gaps between the retainer and surface of the front bumper.



HINT:

When installing the retainer, align the keyhole and snap as shown in the illustration.



Hide 89341A 2.INSTALL NO. 1 ULTRASONIC SENSOR

a.

Engage the 2 claws to install the No. 1 ultrasonic sensor to the No. 1 ultrasonic sensor retainer.

NOTICE:

Push the No. 1 ultrasonic sensor retainer from the outside of the bumper when there is a gap between the retainer and the bumper surface. In this case, do not push on the ultrasonic sensor.



Hide 89348J 3.INSTALL ULTRASONIC SENSOR CLIP

a.

Engage the 4 claws to install the ultrasonic sensor clip.


b.

Engage the clamp.


c.

Connect the connector.


Hide 4.INSTALL REAR BUMPER ASSEMBLY