Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › CLEARANCE WARNING ECU
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0074568 CLEARANCE WARNING ECU A

PARK ASSIST / MONITORING  CLEARANCE WARNING ECU  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 67913 3.REMOVE FRONT DOOR SCUFF PLATE RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62111A 4.REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL


Hide 62311B 5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

Hide 55317A 6.REMOVE INSTRUMENT SIDE PANEL RH

Hide 53921B 7.REMOVE FRONT PANEL GARNISH RH

Hide 55607 8.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (for LHD)

Hide 55303B 9.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)

Hide 55431B 10.REMOVE UPPER INSTRUMENT PANEL FINISH PANEL (for RHD)

Hide 53601 11.DISCONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY (for RHD)

Hide 55432D 12.REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for RHD)

Hide 73900 13.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for RHD)

Hide 82877 14.REMOVE ECU INTEGRATION BOX RH

a.

for LHD:

i.

Disconnect each connector.


ii.
E223728

Remove the bolt, 2 nuts and ECU integration box RH.



b.

for RHD:

i.

Disconnect each connector.


ii.
E227952

Remove the bolt, 2 nuts and ECU integration box RH.



Hide 89340A 15.REMOVE CLEARANCE WARNING ECU ASSEMBLY

a.

for LHD:

i.
E223729

Disengage the 2 claws and remove the clearance warning ECU assembly.



b.

for RHD:

i.
E229573

Disengage the 2 claws and remove the clearance warning ECU assembly.