Home › Power Source / Network › 2GR-FE BATTERY / CHARGING › CHARGING SYSTEM
RM2030EQ _57 Power Source / Network _014661 2GR-FE BATTERY / CHARGING _0074569 CHARGING SYSTEM J

2GR-FE BATTERY / CHARGING  CHARGING SYSTEM  Charge Warning Light Comes ON while Driving  


INSPECTION PROCEDURE

PROCEDURE

1.CHECK LOCK FUNCTION OF GENERATOR PULLEY WITH CLUTCH
a.

Check the lock function with the pulley installed in the vehicle.

i.

Visually check that the rotor in the generator operates with the engine running.



b.

Check the lock function with the pulley removed from the vehicle.

i.

Remove the generator pulley cap.


ii.
A240512
0.833,0.677 1,0.979 0.167,0.302 10 *a 2.51,0.708 2.677,1.01 0.167,0.302 10 *b
*a Free
*b Lock


Hold the generator rotor using SST, and turn the generator pulley with clutch clockwise to check that the outer ring locks.

Click herePower Source / Network>2GR-FE BATTERY / CHARGING>GENERATOR>INSPECTION

OK:

The outer ring locks.




SST
09820-63021  

Result:
Result
OK
NG



OK

2.CHECK INSTALLATION OF GENERATOR PULLEY WITH CLUTCH

NG

REPLACE GENERATOR PULLEY WITH CLUTCH

2.CHECK INSTALLATION OF GENERATOR PULLEY WITH CLUTCH
a.

Start the engine and visually check the generator pulley with clutch for looseness.

OK:

The generator pulley with clutch is not loose.



Result:
Result
OK
NG



OK

NG

TIGHTEN GENERATOR PULLEY WITH CLUTCH TO THE SPECIFIED TORQUE