Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
69760C
1.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY
69720B
2.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
69040A
3.INSTALL FRONT DOOR LOCK WITH MOTOR ASSEMBLY
When reusing the removed front door lock with motor assembly, replace the door lock wiring harness seal on the connector with a new one.
Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.
Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the front door with motor lock assembly.
Apply MP grease to the sliding parts of the front door lock with motor assembly.
When reusing the front door lock with motor assembly.
Install a new door lock wiring harness seal to the front door lock with motor assembly.
| *1 | Front Door Lock Open Rod |
Insert the front door lock open rod to the front door lock with motor assembly.
Make sure that the front door lock open rod is securely connected to the front door lock with motor assembly.
Using a T30 "TORX" socket wrench, install the front door lock with motor assembly with the 3 screws.
4.INSTALL FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)
67404F
5.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
68151C
6.INSTALL FRONT DOOR GLASS RUN
68102
7.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY
67832
8.INSTALL FRONT DOOR SERVICE HOLE COVER
68172A
9.INSTALL FRONT DOOR INNER GLASS WEATHERSTRIP
67602
10.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY
81230
11.INSTALL COURTESY LIGHT ASSEMBLY
74220
12.INSTALL FRONT ARMREST ASSEMBLY
13.INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)
14.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)
67492A
15.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH
69284C
16.INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG
17.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
18.INITIALIZE POWER WINDOW CONTROL SYSTEM
19.CHECK POWER WINDOW CONTROL SYSTEM