Home › Vehicle Interior › DOOR LOCK › REAR DOOR LOCK
RM2030EQ _58 Vehicle Interior _014664 DOOR LOCK _0074583 REAR DOOR LOCK A

DOOR LOCK  REAR DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 69780B 1.INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

Hide 69740D 2.INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

Hide 69060A 3.INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY

NOTICE:
·

When reusing the removed rear door lock with motor assembly, replace the door lock wiring harness seal on the connector with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal surface of the connector.

·

Reusing the door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water intrusion. This may result in a malfunction of the rear door with motor lock assembly.



a.

Apply MP grease to the sliding parts of the rear door lock with motor assembly.


b.

When reusing the rear door with motor lock assembly:

i.
B280422

Install a new door lock wiring harness seal to the rear door lock with motor assembly.



c.
B280421C09
3.146,2.906 2.979,2.844 false 3.177,2.844 3.427,3.042 0.25,0.198 10 false *1
*1 Release Plate


Insert the rear door lock with motor assembly to the rear door outside handle release plate, and set it to the rear door panel.


d.

Make sure that the rear door outside handle frame release plate is securely connected to the rear door lock with motor assembly.


e.

Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.

Torque:
5.0 N*m (51 kgf*cm, 44 in.*lbf)


Hide 68104 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 68124B 5.INSTALL REAR DOOR QUARTER WINDOW GLASS

a.
B280411

Install the rear door quarter window glass in the direction indicated by the arrow in the illustration.


Hide 67408F 6.INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

Hide 68152C 7.INSTALL REAR DOOR GLASS RUN

Hide 67842E 9.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 68174A 10.INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

Hide 67604 11.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74260 12.INSTALL REAR ARMREST ASSEMBLY

Hide 13.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 69284D 14.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 15.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 16.INITIALIZE POWER WINDOW CONTROL SYSTEM