When there are communication malfunctions between the ECM and certification ECU (smart key ECU assembly), or when the communication ID codes do not match, the ECM stores this DTC.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Note |
|---|---|---|---|---|
| B2799 | Engine Immobiliser System Malfunction | Either condition is met (1 trip detection logic*):
·
A malfunction in the communication or communication lines between the ECM and certification ECU (smart key ECU assembly). ·
A matching communication code cannot be verified during communication between the ECM and certification ECU (smart key ECU assembly). |
·
Certification ECU (smart key ECU assembly) ·
ECM ·
Wire harness or connector |
DTC Output Confirmation Operation
Either condition is met: ·
Within 10 seconds of an engine start operation being performed (with the shift lever in P and the brake pedal depressed, the engine switch is pressed while carrying the key). If there is a malfunction, the engine stops (communication begins within 3 seconds of the engine start operation being performed, and DTCs are stored after 6 seconds). ·
10 seconds after the engine switch is turned on (IG) after reconnecting the cable to the negative (-) battery terminal (communication begins within 3 seconds of the engine switch being turned on (IG), and DTCs are stored after 6 seconds). |
*: Only output while a malfunction is present.
| Vehicle Condition when Malfunction Detected | Fail-safe Operation when Malfunction Detected |
|---|---|
| Engine cannot be started | - |
| DTC Code | Data List and Active Test |
|---|---|
| B2799 | - |
When replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.
After performing repairs, perform the operation that fulfills the DTC output confirmation operation, and then confirm that no DTCs are output again.
When DTC B2799 and the certification ECU (smart key ECU assembly) DTC are output simultaneously, first perform troubleshooting for the certification ECU (smart key ECU assembly) DTC.
Disconnect the A43 certification ECU (smart key ECU assembly) connector.
Disconnect the A25 ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A43-14 (EFII) - A25-30 (IMO) | Always | Below 1 Ω |
| A25-30 (IMO) - Body ground | Always | 10 kΩ or higher |
| A43-13 (EFIO) - A25-31 (IMI) | Always | Below 1 Ω |
| A25-31 (IMI) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Register the ECU communication ID.
Refer to the Service Bulletin.
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B2799 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Temporarily replace the ECM with a new or known good one.
Click hereEngine / Hybrid System>2GR-FE ENGINE CONTROL>ECM>REMOVAL
| Proceed to |
|---|
| NEXT |
NEXT
Clear the DTCs.
| Proceed to |
|---|
| NEXT |
NEXT
Check for DTCs.
Before checking for DTCs, perform the "DTC Output Confirmation Operation" procedure.
DTC B2799 is not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG