Home › Engine / Hybrid System › 2GR-FE ENGINE CONTROL › ECM › 2012.02–2015.04
RM2030EQ _51 Engine / Hybrid System _014634 2GR-FE ENGINE CONTROL _0074399 ECM A

2GR-FE ENGINE CONTROL  ECM  REMOVAL  


CAUTION / NOTICE / HINT

HINT:

When removing only the ECM, it is not necessary to remove the cool air intake duct seal and battery.


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable from the negative (-) battery terminal, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 53295E 3.REMOVE COOL AIR INTAKE DUCT SEAL

Hide 89661 5.REMOVE ECM

a.
A254787

Disconnect the 2 ECM connectors.

i.

Push in the locks on the 2 levers, raise the levers, and disconnect the 2 ECM connectors.

NOTICE:

After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting part of the connectors.




b.
A254792E01
2.49,0.74 2.615,0.896 0.125,0.156 10 A 2.396,1.198 2.521,1.354 0.125,0.156 10 B

Remove the nut.


c.

Remove the screw (A).


d.

Loosen the screw (B) and remove the ECM.


e.

Remove the screw (B).


f.
A254793

Remove the 2 screws and No. 2 ECM bracket.


Hide 89667E 6.REMOVE NO. 1 ECM BRACKET

a.
A254783

Remove the nut.


b.

Disconnect the wire harness clamp.


c.
A254786

Disconnect the wire harness clamp.


d.
A249913

Remove the nut and No. 1 ECM bracket.