The certification ECU (smart key ECU assembly) blinks the security indicator light when the immobiliser is set (engine switch off, or driver door is opened and closed with engine switch on (IG)).
w/ Theft Deterrent System:
The certification ECU (smart key ECU assembly) receive the security indicator light signal from the main body ECU (multiplex network body ECU) via CAN communication when the theft deterrent system is arming preparation state or alarm sounding state. Then, certification ECU (smart key ECU assembly) blinks the security indicator light.
Before replacing the certification ECU (smart key ECU assembly), refer to the Service Bulletin.
The engine immobiliser system (w/ Smart Entry and Start System) uses the CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting. Troubleshoot the engine immobiliser system (w/ Smart Entry and Start System) after confirming that the communication systems are functioning properly.
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester on.
Enter the following menus: Body / Entry&Start / Active Test.
Perform the Active Test according to the display on the intelligent tester.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Immobiliser Indicator | Security indicator light | OFF/ON | - |
| Tester Display |
|---|
| Immobiliser Indicator |
The security indicator light operates normally.
| Result | Proceed to |
|---|---|
| OK (w/ Theft Deterrent System) | A |
| OK (w/o Theft Deterrent System) | B |
| NG | C |
A
B
C
When the immobiliser is set, check that the security indicator light blinks.*1
The security indicator light blinks normally.
When the theft deterrent system is in the arming preparation state, check that the security indicator light on.*2
Click hereVehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>THEFT DETERRENT SYSTEM>SYSTEM DESCRIPTION
The security indicator light is on normally.
| Result | Proceed to |
|---|---|
| *1 is NG (*2 is OK) | A |
| *2 is NG (*1 is OK) | B |
A
B
Disconnect the I56 security indicator light (heater control switch board) connector.
Disconnect the I78 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I78-18 (IND)- I56-1 (LP) | Always | Below 1 Ω |
| I78-18 (IND) - Body ground | Always | 10 kΩ or higher |
| I56-6 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the I78 certification ECU (smart key ECU assembly) connector.
Measure the voltage and check the pulse according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I56-1 (LP) - I56-6 (GND) | Engine switch off → Engine switch on (IG) | Pulse generation → Below 2 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG