Home › Vehicle Interior › SEAT BELT › FRONT SEAT OUTER BELT ASSEMBLY
RM2030EQ _58 Vehicle Interior _014671 SEAT BELT _0074646 FRONT SEAT OUTER BELT ASSEMBLY A

SEAT BELT  FRONT SEAT OUTER BELT ASSEMBLY  INSTALLATION  


PROCEDURE

Hide 73200A 1.INSTALL FRONT SHOULDER BELT ANCHOR ADJUSTER ASSEMBLY

a.
B271086E05
2.552,1.729 2.875,1.927 0.323,0.198 10 false <A> 2.458,0.521 2.781,0.719 0.323,0.198 10 false <B>

Engage the guide.


b.

Install the bolt <A> first, then the bolt <B> to temporarily install the front shoulder belt anchor adjuster assembly.


c.

Fully tighten the 2 bolts.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 73220 2.INSPECT FRONT SEAT OUTER BELT ASSEMBLY

Hide 73220 3.INSTALL FRONT SEAT OUTER BELT ASSEMBLY

a.
B279535E02
2.688,0.823 3.01,1.021 0.323,0.198 10 false <A> 2.49,1.802 2.854,2.073 0.365,0.271 10 false <B>

Install the bolt <A> first, then the bolt <B> to temporarily install the front seat outer belt assembly.


b.

Fully tighten the 2 bolts.

Torque:
Bolt <A> : 7.5 N*m (76 kgf*cm, 66 in.*lbf)
Bolt <B> : 42 N*m (428 kgf*cm, 31 ft.*lbf)


c.
B279536

Connect the pretensioner connector and lock the locking button as shown in the illustration.

NOTICE:

Securely lock the locking button.



d.

Connect the shoulder anchor of the front seat outer belt assembly with the nut.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


Hide 62412B 4.INSTALL CENTER PILLAR UPPER GARNISH

Hide 62414A 5.INSTALL CENTER PILLAR LOWER GARNISH

Hide 73220 6.CONNECT FRONT SEAT OUTER BELT ASSEMBLY

a.

Install the floor anchor of the front seat outer belt assembly with the bolt.

Torque:
42 N*m (428 kgf*cm, 31 ft.*lbf)


b.

Check if the ELR locks.

NOTICE:

The check should be performed with the front seat outer belt assembly installed.


i.

With the belt assembly installed, check that the belt locks when it is pulled out quickly.



Hide 73233 7.INSTALL LAP BELT OUTER ANCHOR COVER

a.

Engage the 3 claws to install the lap belt outer anchor cover.


Hide 62332A 8.INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

Hide 67918A 9.INSTALL REAR DOOR SCUFF PLATE

Hide 62312B 10.INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

Hide 67914 11.INSTALL FRONT DOOR SCUFF PLATE

Hide 12.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION