Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PRESSURE SENSOR
RM2030EQ _58 Vehicle Interior _014672 HEATING / AIR CONDITIONING _0074663 AIR CONDITIONING PRESSURE SENSOR A

HEATING / AIR CONDITIONING  AIR CONDITIONING PRESSURE SENSOR  INSTALLATION  


PROCEDURE

Hide 88719A 1.INSTALL AIR CONDITIONING PRESSURE SENSOR

a.

Apply a sufficient amount of compressor oil to a new air conditioning pressure sensor.

Compressor oil:

ND-OIL 8 or equivalent


NOTICE:
·

Keep the O-ring and O-ring fitting surfaces free of foreign matter.

·

Do not use any compressor oil other than ND-OIL 8 or equivalent.




b.

Using a 27 mm deep socket wrench, install the new air conditioning pressure sensor.

Torque:
11 N*m (110 kgf*cm, 8 ft.*lbf)

NOTICE:
·

Do not deform the piping.

·

Make sure to confirm that the piping does not disengage from the plastic clamp.




c.

Connect the connector.


Hide 2.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT