Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM
RM2030EQ _59 Vehicle Exterior _014675 WINDOW / GLASS _0074675 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Rear Power Window LH does not Operate with Rear Power Window Switch LH  


DESCRIPTION

When the ignition switch is ON, the power window regulator motor assembly (for rear LH door) is operated by the power window regulator switch assembly (for rear LH door).

WIRING DIAGRAM

B246035
4.354,3.094 5.917,3.51 1.563,0.417 10 false Power Window Regulator Master Switch Assembly 6.208,3.083 6.958,3.26 0.75,0.177 10 false *1: for LHD 6.208,3.333 6.958,3.51 0.75,0.177 10 false *2: for RHD 2.344,2.781 3.906,3.365 1.563,0.583 10 false Power Window Regulator Switch Assembly (for Rear LH Door) 0.281,2.771 1.865,3.323 1.583,0.552 10 false Power Window Regulator Motor Assembly (for Rear LH Door) 4.354,2.938 5.385,3.229 1.031,0.292 10 false K10*1, J10*2 2.344,2.625 2.708,2.906 0.365,0.281 10 false M6 0.292,2.615 0.635,2.844 0.344,0.229 10 false M5 6.188,2.26 6.302,2.406 0.115,0.146 10 false E 6.385,2.25 7.146,2.5 0.76,0.25 10 false 1*1, 9*2 5.229,1.635 5.344,1.781 0.115,0.146 10 false B 5.396,1.427 5.51,1.573 0.115,0.146 10 false 6 4.396,2.042 4.531,2.188 0.135,0.146 10 false U 2.729,1.948 2.865,2.094 0.135,0.146 10 false U 2.552,1.948 2.688,2.094 0.135,0.146 10 false 4 1.354,1.948 1.49,2.094 0.135,0.146 10 false U 1.521,1.948 1.656,2.094 0.135,0.146 10 false 1 3.219,2.052 3.438,2.198 0.219,0.146 10 false SU 3.167,1.906 3.292,2.052 0.125,0.146 10 false B 3.229,2.438 3.583,2.667 0.354,0.229 10 false SD 4.396,2.438 4.531,2.583 0.135,0.146 10 false D 2.729,2.323 2.865,2.469 0.135,0.146 10 false D 2.552,2.323 2.688,2.469 0.135,0.146 10 false 1 1.354,2.323 1.49,2.469 0.135,0.146 10 false D 1.521,2.323 1.656,2.469 0.135,0.146 10 false 2 3.177,1.719 3.313,1.865 0.135,0.146 10 false 3 3.5,2.063 3.635,2.208 0.135,0.146 10 false 5 3.667,2.031 4.719,2.417 1.052,0.385 10 false 12*1, 18*2 3.677,2.438 4.615,2.76 0.938,0.323 10 false 13*1, 10*2 3.5,2.438 3.75,2.688 0.25,0.25 10 false 2 3.729,0.906 4.698,1.188 0.969,0.281 10 false DOOR NO. 1 2,1.427 2.729,1.573 0.729,0.146 10 false DOOR R/L 0.292,0.719 1.708,1.188 1.417,0.469 10 false from DOOR Relay

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following procedure.


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR REAR LH DOOR) - BATTERY)
a.

Disconnect the power window regulator switch assembly (for rear LH door) connector.


b.

Measure the voltage according to the value(s) in the table below.

Standard Voltage:
Tester Connection Condition Specified Condition
M6-3 (B) - Body ground Ignition switch ON 11 to 14 V



Result:
Proceed to
OK
NG



OK

2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR REAR LH DOOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR REAR LH DOOR)
a.
B164433
2.177,2.188 2.385,2.74 false 1.938,2.188 2.063,2.74 false 1.521,2.188 1.427,2.74 false 1.292,2.188 1.094,2.74 false 1.729,2.177 1.729,2.729 false 0.198,0.219 0.385,0.365 0.188,0.146 10 *a 1.385,2.75 1.521,2.896 0.135,0.146 10 U 0.969,2.75 1.281,3.01 0.313,0.26 10 SU 2.385,2.75 2.521,2.896 0.135,0.146 10 D 1.698,2.75 1.833,2.896 0.135,0.146 10 B 1.979,2.75 2.198,2.896 0.219,0.146 10 SD
*a Component without harness connected
(Power Window Regulator Switch Assembly (for Rear LH Door))


Remove the power window regulator switch assembly (for rear LH door).

Click hereVehicle Exterior>WINDOW / GLASS>REAR POWER WINDOW SWITCH>REMOVAL


b.

Measure the resistance when the switch is operated according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 (D) - 2 (SD) UP Below 1 Ω
3 (B) - 4 (U) Below 1 Ω
1 (D) - 2 (SD) off Below 1 Ω
4 (U) - 5 (SU) Below 1 Ω
4 (U) - 5 (SU) DOWN Below 1 Ω
1 (D) - 3 (B) Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH (FOR REAR LH DOOR) - POWER WINDOW REGULATOR MOTOR)

NG

REPLACE POWER WINDOW REGULATOR SWITCH ASSEMBLY (FOR REAR LH DOOR)

3.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR SWITCH (FOR REAR LH DOOR) - POWER WINDOW REGULATOR MOTOR)
a.

Disconnect the power window regulator motor assembly (for rear LH door) connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
M6-4 (U) - M5-1 (U) Always Below 1 Ω
M6-1 (D) - M5-2 (D) Always Below 1 Ω
M6-4 (U) - Body ground Always 10 kΩ or higher
M6-1 (D) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY
a.
B164359
2.365,1.771 2.635,2.688 false 1.51,1.792 1.229,2.708 false 2.021,1.99 1.906,2.698 false 1.813,2.021 1.583,2.708 false 1.073,1.99 0.74,2.656 false 1.063,1.781 0.458,2.698 false 2.313,1.99 2.198,2.698 false 0.198,0.083 0.385,0.271 0.188,0.188 10 *a 1.792,2.698 2.385,2.969 0.594,0.271 10 U*A 1.469,2.698 1.781,2.958 0.313,0.26 10 D*A 1.167,2.708 1.302,2.896 0.135,0.188 10 B 2.604,2.698 3.042,2.969 0.438,0.271 10 E*A 0.594,2.698 1.188,2.969 0.594,0.271 10 U*B 0.271,2.708 0.708,2.979 0.438,0.271 10 E*B 2.115,2.698 2.427,2.958 0.313,0.26 10 D*B
*A for LHD
*B for RHD
*a Component without harness connected
(Power Window Regulator Master Switch Assembly)


Remove the power window regulator master switch assembly.

Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL


b.

Measure the resistance when the switch is operated according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
6 (B) - 12 (U) UP Below 1 Ω
1 (E) - 13 (D) Below 1 Ω
1 (E) - 12 (U) off Below 1 Ω
1 (E) - 13 (D) Below 1 Ω
6 (B) - 13 (D) DOWN Below 1 Ω
1 (E) - 12 (U) Below 1 Ω

for RHD
Tester Connection Condition Specified Condition
6 (B) - 18 (U) UP Below 1 Ω
9 (E) - 10 (D) Below 1 Ω
9 (E) - 18 (U) off Below 1 Ω
9 (E) - 10 (D) Below 1 Ω
6 (B) - 10 (D) DOWN Below 1 Ω
9 (E) - 18 (U) Below 1 Ω



Result:
Proceed to
OK
NG



OK

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH - POWER WINDOW REGULATOR SWITCH (FOR REAR LH DOOR))

NG

REPLACE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY

5.CHECK HARNESS AND CONNECTOR (POWER WINDOW REGULATOR MASTER SWITCH - POWER WINDOW REGULATOR SWITCH (FOR REAR LH DOOR))
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
for LHD
Tester Connection Condition Specified Condition
K10-12 (U) - M6-5 (SU) Always Below 1 Ω
K10-13 (D) - M6-2 (SD) Always Below 1 Ω
K10-12 (U) - Body ground Always 10 kΩ or higher
K10-13 (D) - Body ground Always 10 kΩ or higher

for RHD
Tester Connection Condition Specified Condition
J10-18 (U) - M6-5 (SU) Always Below 1 Ω
J10-10 (D) - M6-2 (SD) Always Below 1 Ω
J10-18 (U) - Body ground Always 10 kΩ or higher
J10-10 (D) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (FOR REAR LH DOOR)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR