Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
69284D
3.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG
4.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
74260
5.REMOVE REAR ARMREST ASSEMBLY
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY
68174A
7.REMOVE REAR DOOR INNER GLASS WEATHERSTRIP
67842E
8.REMOVE REAR DOOR SERVICE HOLE COVER
67872
9.DISCONNECT REAR DOOR WEATHERSTRIP
Disconnect the upper part of rear door weatherstrip as shown in the illustration.
68152C
10.REMOVE REAR DOOR GLASS RUN
67408F
11.REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY
68124B
12.REMOVE REAR DOOR QUARTER WINDOW GLASS
Remove the rear door quarter window glass with the rear door quarter window weatherstrip as shown in the illustration.
68104
13.REMOVE REAR DOOR GLASS SUB-ASSEMBLY
14.REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY
85720E
15.REMOVE REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY