Home › Vehicle Exterior › DOOR / HATCH › HOOD
RM2030EQ _59 Vehicle Exterior _014677 DOOR / HATCH _0074688 HOOD N

DOOR / HATCH  HOOD  ADJUSTMENT  


CAUTION / NOTICE / HINT

B277160C07
0.667,0.281 1.073,0.552 0.406,0.271 10 false *1 2.563,0.281 2.917,0.552 0.354,0.271 10 false *2
*1 Centering Bolt
*2 Standard Bolt


HINT:
·

Centering bolts are used to mount the hood hinge and hood lock. The hood and hood lock cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

Specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 1.INSPECT HOOD SUB-ASSEMBLY

Hide 2.ADJUST HOOD SUB-ASSEMBLY

a.

Horizontally and vertically adjust the hood.

i.
B277161

Loosen the 4 hinge bolts of the hood.


ii.

Adjust the clearance between the hood and front fender by moving the hood.


iii.

Tighten the 4 hinge bolts after the adjustment.

Torque:
13 N*m (133 kgf*cm, 10 ft.*lbf)



b.

Adjust the height of the front end of the hood using the cushion rubbers.

i.
B308590

Adjust the 2 cushion rubbers so that the heights of the hood and fender are aligned.

HINT:

Raise or lower the front end of the hood by turning the 2 cushion rubbers.




c.

Remove the front bumper assembly.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>REMOVAL


d.

Adjust the hood lock.

i.
B281661C09
2.792,1.375 3.125,1.448 false 2.635,1.271 2.948,1.521 0.313,0.25 10 false *1
*1 Protective Tape


Using a screwdriver, remove the hood lock nut cap.

HINT:

Tape the screwdriver tip before use.



ii.
B281662C05
1.76,1.5 1.25,1.865 false 1.073,1.802 1.479,2.094 0.406,0.292 10 false *1
*1 Hood Lock Bolt


Loosen the 2 bolts and hood lock bolt.


iii.

Adjust the hood lock and tighten the 2 bolts and hood lock bolt.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


iv.

Check that the striker can engage with the hood lock smoothly.



e.
B281663

Install a new hood lock nut cap.


f.

Install the front bumper assembly.

Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>FRONT BUMPER>INSTALLATION