Home › Vehicle Exterior › DOOR / HATCH › LUGGAGE COMPARTMENT DOOR
RM2030EQ _59 Vehicle Exterior _014677 DOOR / HATCH _0074693 LUGGAGE COMPARTMENT DOOR N

DOOR / HATCH  LUGGAGE COMPARTMENT DOOR  ADJUSTMENT  


CAUTION / NOTICE / HINT

B280558C05
2.458,0.167 2.844,0.479 0.385,0.313 10 false *2 0.792,0.167 1.146,0.479 0.354,0.313 10 false *1
*1 Centering Bolt
*2 Standard Bolt


HINT:
·

Centering bolts are used to mount the door hinge to the door. The door cannot be adjusted with the centering bolts installed. Substitute the centering bolts with standard bolts when making adjustments.

·

Specified torque for standard bolts is shown in the standard bolt chart.

Click hereGeneral>SPECIFICATIONS>STANDARD BOLT>SPECIFIED TORQUE FOR STANDARD BOLTS



PROCEDURE

Hide 64719A 1.REMOVE LUGGAGE COMPARTMENT DOOR COVER

Hide 64711 2.REMOVE LUGGAGE COMPARTMENT FLOOR MAT

Hide 58387 3.REMOVE REAR FLOOR FINISH PLATE

Hide 4.ADJUST LUGGAGE COMPARTMENT DOOR

a.
B280559

Loosen the door side hinge bolts to adjust the door horizontally and vertically.

Torque:
7.5 N*m (77 kgf*cm, 66 in.*lbf)


b.
B280560

Using a T40 "TORX" socket wrench, slightly loosen the striker mounting screws.


c.

Using a brass bar and a hammer, hit the striker to adjust its position.


d.

Using a T40 "TORX" socket wrench, tighten the striker mounting screws after adjustment.

Torque:
23 N*m (235 kgf*cm, 17 ft.*lbf)


Hide 58387 5.INSTALL REAR FLOOR FINISH PLATE

Hide 64711 6.INSTALL LUGGAGE COMPARTMENT FLOOR MAT

Hide 64719A 7.INSTALL LUGGAGE COMPARTMENT DOOR COVER

Hide 8.INSPECT LUGGAGE COMPARTMENT DOOR

a.

Check that the clearance measurements of areas *a through *d are within each standard range.

B281700E02
1.135,1.01 1.5,1.25 0.365,0.24 10 false *a 2.698,0.927 3.042,1.177 0.344,0.25 10 false *b 2.885,1.75 3.271,2.01 0.385,0.26 10 false *c 6,1.417 6.323,1.656 0.323,0.24 10 false *d

Standard Clearance
Area Measurement Area Measurement
*a 6.4 mm (0.252 in.) *b 2.0 to 5.0 mm (0.0787 to 0.197 in.)
*c -1.0 to 2.0 mm (-0.0394 to 0.0787 in.) *d 3.7 to 7.7 mm (0.146 to 0.303 in.)