Home › Vehicle Exterior › LIGHTING (EXT) › LICENSE PLATE LIGHT ASSEMBLY
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074726 LICENSE PLATE LIGHT ASSEMBLY A

LIGHTING (EXT)  LICENSE PLATE LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH and LH sides.

·

The procedure described below is for the LH side.



PROCEDURE

Hide 76801A 1.REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY

Hide 81270 2.REMOVE LICENSE PLATE LIGHT ASSEMBLY

a.
E227541

Disconnect the connector.


b.

Disengage the 2 claws and remove the license plate light assembly.


Hide 81274B 3.REMOVE LICENSE PLATE LIGHT PACKING

a.
E226676

Remove the license plate light packing.

NOTICE:

Do not reuse the removed packing. Be sure to install a new license plate light packing to prevent water ingress.



Hide 81271 4.REMOVE LICENSE PLATE LIGHT LENS

a.
E255008
1.365,1.813 0.635,1.813 false 0.969,1.552 0.594,1.271 false 0.479,1.719 0.646,1.865 0.167,0.146 10 false *1 0.406,1.167 0.573,1.313 0.167,0.146 10 false *a
*1 Protective Tape
*a Insert into the hole


Insert a screwdriver wrapped with protective tape into the license plate light lens hole, tilt it in the direction shown in the illustration and disengage the 2 claws to remove the license plate light lens.


Hide 81270B 5.REMOVE LICENSE PLATE LIGHT BULB

a.
E255009

Remove the license plate light bulb.