Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › 2012.02–2015.04
RM2030EQ _59 Vehicle Exterior _014682 EXTERIOR PANELS / TRIM _0074745 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  DISASSEMBLY  


PROCEDURE

Hide 1.REMOVE REAR LOWER SPOILER SUB-ASSEMBLY (w/ Rear Under Spoiler)

a.

Remove the 2bolts, 26 clips.

B308041


b.

Disengage the 24 guides and rear lower spoiler sub-assembly.

B308040


Hide 76875 2.REMOVE NO. 4 REAR SPOILER PROTECTOR (w/ Rear Under Spoiler)

a.
B308039

No. 4 rear spoiler protector.

HINT:

Use the same procedure for the RH side and LH side.



Hide 52153C 3.REMOVE REAR BUMPER EXTENSION LH (w/ Rear Under Spoiler)

a.
B308042

Remove the 2 nuts and remove the rear bumper extension LH.


Hide 52152D 4.REMOVE REAR BUMPER EXTENSION RH (w/ Rear Under Spoiler)

HINT:

Use the same procedure as for the LH side.


Hide 52463 5.REMOVE REAR BUMPER PAD LH

a.
B282079

Remove the rear bumper pad LH.


Hide 52462 6.REMOVE REAR BUMPER PAD RH

a.
B282078

Remove the rear bumper pad RH.


Hide 81920 7.REMOVE REFLEX REFLECTOR ASSEMBLY LH

a.
B282091

Remove the screw.


b.

Disengage the guide and remove the reflex reflector assembly LH.


Hide 81910 8.REMOVE REFLEX REFLECTOR ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 9.REMOVE NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)

a.
B314786

Disengage the 2 clamps.


b.

Disconnect the 2 connectors and remove the No. 2 luggage room wire.


Hide 89348J 10.REMOVE ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)

Hide 89341A 11.REMOVE NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89348A 12.REMOVE NO. 2 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

Hide 52576 13.REMOVE REAR BUMPER SIDE RETAINER LH

a.
B280046

Remove the 3 screws.


b.

Disengage the 6 claws and remove the rear bumper side retainer LH.


Hide 52575 14.REMOVE REAR BUMPER SIDE RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 61648H 15.REMOVE WHEEL HOUSE REINFORCEMENT LH

a.
B280052

Remove the screw and nut.


b.

Disengage the clip and remove the wheel house reinforcement LH.


Hide 61647F 16.REMOVE WHEEL HOUSE REINFORCEMENT RH

HINT:

Use the same procedure as for the LH side.


Hide 52023 17.REMOVE REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

a.
B294688

Remove the 6 nuts and rear bumper reinforcement sub-assembly.