Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › REAR BUMPER › 2012.02–2015.04
RM2030EQ _59 Vehicle Exterior _014682 EXTERIOR PANELS / TRIM _0074745 REAR BUMPER A

EXTERIOR PANELS / TRIM  REAR BUMPER  REASSEMBLY  


PROCEDURE

Hide 52023 1.INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

a.
B294688

Install the rear bumper reinforcement sub-assembly with the 6 nuts.

Torque:
61 N*m (622 kgf*cm, 45 ft.*lbf)


Hide 61648H 2.INSTALL WHEEL HOUSE REINFORCEMENT LH

a.
B280052

Engage the clip.


b.

Install the wheel house reinforcement LH with the screw and nut.


Hide 61647F 3.INSTALL WHEEL HOUSE REINFORCEMENT RH

HINT:

Use the same procedure as for the LH side.


Hide 52576 4.INSTALL REAR BUMPER SIDE RETAINER LH

a.
B280046

Engage the 6 claws.


b.

Install the rear bumper side retainer LH with the 3 screws.

Torque:
3.0 N*m (31 kgf*cm, 27 in.*lbf)


Hide 52575 5.INSTALL REAR BUMPER SIDE RETAINER RH

HINT:

Use the same procedure as for the LH side.


Hide 89348A 6.INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (w/ TOYOTA Parking Assist-sensor System)

Hide 89341A 7.INSTALL NO. 1 ULTRASONIC SENSOR (w/ TOYOTA Parking Assist-sensor System)

Hide 89348J 8.INSTALL ULTRASONIC SENSOR CLIP (w/ TOYOTA Parking Assist-sensor System)

Hide 9.INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ TOYOTA Parking Assist-sensor System)

a.
B314786

Connect the 2 connectors.


b.

Engage the 2 clamps to install the No. 2 luggage room wire.


Hide 81920 10.INSTALL REFLEX REFLECTOR ASSEMBLY LH

a.
B282091

Engage the guide.


b.

Install the reflex reflector assembly LH with the screw.


Hide 81910 11.INSTALL REFLEX REFLECTOR ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 52463 12.INSTALL REAR BUMPER PAD LH

a.

Wipe off any tape adhesive residue with cleaner.


b.
B282079

Install a new rear bumper pad LH.

HINT:

Stick the new rear bumper pad LH on the line marked on the rear bumper assembly.



Hide 52462 13.INSTALL REAR BUMPER PAD RH

a.

Wipe off any tape adhesive residue with cleaner.


b.
B282078

Install a new rear bumper pad RH.

HINT:

Stick the new rear bumper pad RH on the line marked on the rear bumper assembly.



Hide 52153C 14.INSTALL REAR BUMPER EXTENSION LH (w/ Rear Under Spoiler)

a.
B308042

Install the rear bumper extension LH with the 2 nuts.


Hide 52152D 15.INSTALL REAR BUMPER EXTENSION RH (w/ Rear Under Spoiler)

HINT:

Use the same procedure as for the LH side.


Hide 76875 16.INSTALL NO. 4 REAR SPOILER PROTECTOR (w/ Rear Under Spoiler)

a.

Clean the rear lower spoiler.

i.

Remove any double-sided tape from the rear lower spoiler.


ii.

Wipe off any tape adhesive residue with cleaner.



b.

Install a new No. 4 rear spoiler protector.

i.

Remove the release paper from the No. 4 rear spoiler protector.

HINT:

After removing the release paper, keep the exposed adhesive free from foreign matter.



ii.
B308038

Install a new No. 4 rear spoiler protector as shown in the illustration.

HINT:

Use the same procedure for the RH side and LH side.




Hide 17.INSTALL REAR LOWER SPOILER SUB-ASSEMBLY (w/ Rear Under Spoiler)

a.

Engage the 24 guides and install the rear lower spoiler sub-assembly.

B308040


b.

Install the 2bolts, 26 clips.

B308041