Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING
RM2030EQ _59 Vehicle Exterior _014682 EXTERIOR PANELS / TRIM _0074747 FRONT DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR BELT MOULDING  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 3.REMOVE MIRROR SUB-ASSEMBLY WITH COVER

Hide 67832 4.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68102 5.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 75720 6.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY

a.
B280066C07
2.208,1.531 1.646,1.104 false 2.25,1.479 2.521,1.719 0.271,0.24 10 false *1
*1 Protective Tape


Put protective tape around the front door belt moulding assembly.


b.
B280067C07
2.823,0.844 1.99,0.771 false 2.865,0.781 3.156,1.031 0.292,0.25 10 false *1
*1 Protective Tape


Using a screwdriver with the tip wrapped with protective tape, disengage the 6 claws and remove the front door belt moulding assembly.