Home › Drivetrain › U660E AUTOMATIC TRANSMISSION / TRANSAXLE › AUTOMATIC TRANSAXLE SYSTEM
RM2030EQ _52 Drivetrain _014643 U660E AUTOMATIC TRANSMISSION / TRANSAXLE _0076674 AUTOMATIC TRANSAXLE SYSTEM D

U660E AUTOMATIC TRANSMISSION / TRANSAXLE  AUTOMATIC TRANSAXLE SYSTEM  MONITOR DRIVE PATTERN  


TEST MONITOR DRIVE PATTERN FOR ECT


CAUTION:

Perform this drive pattern on a level surface and strictly observe the posted speed limits and traffic laws while driving.


HINT:

Performing this drive pattern is one method to simulate the TCM (ECT) malfunction detection conditions.

Some DTCs may not be detected through ordinary, everyday driving. Also, DTCs may not be detected through this drive pattern.


a.

Preparation for driving

i.

Warm up the engine sufficiently (engine coolant temperature is 60°C (140°F) or higher).


ii.

Drive the vehicle when the atmospheric temperature is -10°C (14°F) or higher.

Some malfunctions are not detected when the atmospheric temperature is less than -10°C (14°F).



b.

Drive pattern

i.

Drive the vehicle through all the gears.

Stop → 1st → 2nd → 3rd → 4th → 5th → 6th → 6th (lock-up ON).


ii.

Confirm engine braking using the S position. While driving with S6 range selected and 6th gear operating with lock-up on, move the shift lever toward "-" to downshift from 6 to 5, 5 to 4, 4 to 3, 3 to 2, 2 to 1.


iii.

Repeat the above drive pattern three times or more.

NOTICE:
·

When using the intelligent tester, the monitor status can be checked in the Data List (See page Drivetrain>U660E AUTOMATIC TRANSMISSION / TRANSAXLE>AUTOMATIC TRANSAXLE SYSTEM>DATA LIST / ACTIVE TEST).

·

In the event that the drive pattern must be interrupted (due to traffic conditions or other factors), the drive pattern can be resumed and, in most cases, the monitor can be completed.



C115866
2.542,3.885 1.615,2.49 false 3.385,3.438 3.115,3.042 false 2.188,1.74 2.729,0.292 2.729,0.292 2.792,0.292 false 4.875,2.073 5.177,1.26 5.177,1.26 5.24,1.26 false 0.198,0.438 1.146,0.646 0.948,0.208 10 false Vehicle Speed 2.865,0.208 5.906,1.01 3.042,0.802 10 false Maintain a constant speed or gradual acceleration (with the throttle valve open) for 3 min. or more.* 5.302,1.188 7.094,1.729 1.792,0.542 10 false Lock-up ON Vehicle Speed 3.417,3.417 4.833,3.771 1.417,0.354 10 false Stop (Idling) 2.542,3.896 4.552,4.583 2.01,0.688 10 false Normal acceleration through all the gears from 1st to 6th 0.135,3.302 1.667,3.583 1.531,0.281 10 false Warmed up sufficiently 0.969,2.906 1.135,3.125 0.167,0.219 10 false 0 0.052,1.917 1.083,2.427 1.031,0.51 10 false Approx. 80 km/h (50 mph) 0.031,0.99 1.156,1.604 1.125,0.615 10 false Approx. 100 km/h (62 mph)

HINT:

*1: Drive the vehicle at a speed in top gear that will cause lock-up to engage. The vehicle can be driven at a speed lower than that in the above diagram under the lock-up condition.


NOTICE:

It is necessary to drive the vehicle for approximately 30 minutes to detect DTC P0711 (ATF temperature sensor malfunction).