Home › Audio / Visual / Telematics › AUDIO / VIDEO › AUDIO AND VISUAL SYSTEM(for Radio and Display Type) › 2012.02–2015.04
RM2030EQ _56 Audio / Visual / Telematics _014658 AUDIO / VIDEO _0076716 AUDIO AND VISUAL SYSTEM(for Radio and Display Type) J

AUDIO / VIDEO  AUDIO AND VISUAL SYSTEM(for Radio and Display Type)  Parking Brake Switch Circuit  


DESCRIPTION

This circuit is from the parking brake switch assembly to the radio and display receiver assembly.

WIRING DIAGRAM

E226166E46
3.688,1.021 4.01,1.323 0.323,0.302 10 1 5.208,1 5.438,1.323 0.229,0.323 10 6 4.563,1.99 5.135,2.24 0.573,0.25 10 I154 4.563,2.156 6.927,2.479 2.365,0.323 10 Radio and Display Receiver Assembly 2.667,1.438 3.042,1.719 0.375,0.281 10 A42 2.667,1.604 3.74,2.146 1.073,0.542 10 Parking Brake Switch Assembly 5.406,1.115 5.833,1.438 0.427,0.323 10 PKB

PROCEDURE

1.CHECK BRAKE WARNING LIGHT
a.

Check that the brake warning light comes on when the parking brake is applied and goes off when it is released.

OK:

The brake warning light operates as specified above.



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)

NG

2.CHECK HARNESS AND CONNECTOR (PARKING BRAKE SWITCH ASSEMBLY - RADIO AND DISPLAY RECEIVER ASSEMBLY)
a.

Disconnect the radio and display receiver assembly connector.


b.

Disconnect the parking brake switch assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I154-6 (PKB) - A42-1 Always Below 1 Ω
I154-6 (PKB) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR