*: Use the intelligent tester.
| Proceed to |
|---|
| NEXT |
NEXT
Interview the customer and confirm the trouble.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Check and record DTCs and Freeze Frame Data.
Clear the DTCs and Freeze Frame Data.
for DTC Check/Clear: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
for Freeze Frame Data: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>FREEZE FRAME DATA
Reconfirm the DTCs.
Reconfirm the DTCs based on the recorded DTCs and Freeze Frame Data.
for DTC Check/Clear: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>DTC CHECK / CLEAR
for Freeze Frame Data: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>FREEZE FRAME DATA
When DTCs indicating CAN communication system malfunctions are output, repair the CAN communication system first.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
If any of U0100, U0123 and U0126 are among the CAN communication DTCs that are output, first use the Data List to check for a momentary open circuit.
If the intelligent tester cannot communicate with the skid control ECU, inspect the CAN communication system.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
If there is no response from the skid control ECU, inspect the +BS circuit of the skid control ECU.
for C1241: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1241
for C1417: Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1417
| Result | Proceed to |
|---|---|
| DTC is output. | A |
| DTC is not output. (Problem symptom does not occur.) | B |
| DTC is not output. (Problem symptom occurs.) | C |
A
B
C
Proceed to Diagnostic Trouble Code Chart.
| Proceed to |
|---|
| NEXT |
NEXT
Proceed to How to Proceed with Troubleshooting.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
| Proceed to |
|---|
| NEXT |
NEXT
Proceed to Problem Symptoms Table.
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT