PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
| System | See Procedure |
|---|---|
| Parking Assist Monitor System | ( )
|
IGNITION SWITCH EXPRESSIONS
The type of ignition switch used on this model differs according to the specification of the vehicle.
The expressions listed in the table below are used in this section.
| Expression | Ignition Switch (Position) | Engine Switch (Condition) |
|---|---|---|
| Ignition Switch off | LOCK | Off |
| Ignition Switch ACC | ACC | On (ACC) |
| Ignition Switch ON | ON | On (IG) |
| Engine Start | START | Start |
HANDLING PRECAUTIONS FOR SRS AIRBAG SYSTEM
This vehicle is equipped with a Supplemental Restraint System (SRS). Failure to carry out service operations in the correct sequence could cause the SRS to unexpectedly deploy during servicing. This may cause a serious accident.
Before servicing (including inspection, replacement, removal and installation of parts), be sure to read the precautionary notices for Supplemental Restraint System.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
PRECAUTIONS FOR REMOVAL, INSTALLATION AND REPLACEMENT OF ELECTRONIC MOTOR POWER STEERING COMPONENTS
Be sure to align the front wheels straight ahead when removing and installing the steering gear assembly.
When disconnecting the steering intermediate shaft assembly, be sure to place matchmarks before starting the operation.
After replacing the power steering ECU assembly, perform assist map writing.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
HANDLING PRECAUTION
When handling the electronic parts:
Avoid any impact to electronic parts such as ECUs and relays. Replace them with new ones if dropped or subjected to a severe impact.
Do not expose any electronic parts to high temperatures or humidity.
Do not touch the connector terminals in order to prevent deformation or malfunctions due to static electricity.
When handling the power steering ECU assembly:
When the power steering ECU assembly has been replaced with a new one, perform assist map writing.
Click hereSteering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION
When disconnecting and reconnecting the connectors:
Before disconnecting the connectors related to the power steering system, turn the ignition switch to ON, center the steering wheel, turn the ignition switch off, and then disconnect the connectors.
Before reconnecting the connectors related to the power steering system, ensure that the ignition switch is off. Then center the steering wheel and turn the ignition switch to ON
Do not turn the ignition switch to ON when the steering wheel is not centered.
PRECAUTIONS FOR CAN COMMUNICATION
CAN communication lines are used to receive information from the ECM and the brake actuator assembly, and to transmit warnings to the combination meter assembly.
When problems are detected in the CAN communication lines, CAN communication DTCs are stored.
Perform troubleshooting for communication problems when CAN communication DTCs are output. Be sure to start troubleshooting the power steering system after confirming that the CAN communication system is normal.
Since the CAN communication lines each have their own length and route, they cannot be repaired temporarily with a bypass wire, etc.