Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM
RM2030EQ _55 Steering _014655 POWER ASSIST SYSTEMS _0077045 POWER STEERING SYSTEM J

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  TS and CG Terminal Circuit  


DESCRIPTION

In Test Mode (signal check), a malfunction in a speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.

Sensor check mode can be entered by connecting terminals TS and CG of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM

C167369E59
0.458,2.927 0.76,3.083 0.302,0.156 10 false I39 0.938,1.792 1.229,2.031 0.292,0.24 10 false CG 0.958,0.906 1.219,1.073 0.26,0.167 10 false TS 1.24,0.813 1.438,0.969 0.198,0.156 10 false 12 1.26,1.698 1.458,1.854 0.198,0.156 10 false 4 5.729,2.927 5.958,3.177 0.229,0.25 10 false j1 6.031,0.906 6.385,1.177 0.354,0.271 10 false TS 5.833,0.813 6.01,0.958 0.177,0.146 10 false 5 5.917,2.927 7.021,3.406 1.104,0.479 10 false Power Steering ECU Assembly 0.719,2.927 1.104,3.083 0.385,0.156 10 false DLC3

INSPECTION PROCEDURE

NOTICE:

If the power steering ECU assembly has been replaced, perform assist map writing (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - TS of DLC3)
a.

Disconnect the power steering ECU assembly connector.


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
j1-5(TS) - I39-12(TS) Always Below 1 Ω
j1-5(TS) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

2.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)
a.
C207407C47
1.51,0.865 1.917,1.115 0.406,0.25 1.188,1.406 1.583,1.885 false 0.177,0.177 0.75,0.594 0.573,0.417 10 *a 1.063,1.219 1.406,1.458 0.344,0.24 10 CG 1.604,0.906 2.01,1.281 0.406,0.375 10 I39
*a Front view of DLC3


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I39-4(CG) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE POWER STEERING ECU ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR