The illuminated entry system controls the engine switch illumination.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Entry&Start / Active Test.
Check that the illumination operates.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Power/Engine SW Light | Engine switch light | OFF/ON | When performing this Active Test, make sure the following condition is met:
The engine switch illumination is off (15 seconds or more have elapsed since it turned from on to off) and the engine switch is on (ACC) or on (IG), or the engine is running. |
| Tester Display |
|---|
| Power/Engine SW Light |
Engine switch illumination comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Remove the engine switch.
Click hereEngine / Hybrid System>2GR-FE STARTING>ENGINE SWITCH>REMOVAL
Inspect the engine switch.
Click hereEngine / Hybrid System>2GR-FE STARTING>ENGINE SWITCH>INSPECTION
Engine switch illumination comes on.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I78 certification ECU (smart key ECU assembly) connector.
Disconnect the I58 engine switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I58-9 (SWIL) - I78-16 (SWIL) | Always | Below 1 Ω |
| I58-6 (AGND) - I78-24 (AGND) | Always | Below 1 Ω |
| I58-9 (SWIL) - Body ground | Always | 10 kΩ or higher |
| I58-6 (AGND) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG