Home › Vehicle Interior › LIGHTING (INT) › LIGHTING SYSTEM
RM2030EQ _58 Vehicle Interior _014666 LIGHTING (INT) _0074614 LIGHTING SYSTEM J

LIGHTING (INT)  LIGHTING SYSTEM  Luggage Compartment Door Courtesy Switch Circuit  


DESCRIPTION

The main body ECU (multiplex network body ECU) detects the condition of the luggage compartment door lock assembly using this circuit.

WIRING DIAGRAM

E227473E09
5.792,0.698 6.031,0.958 0.24,0.26 10 4 5.719,0.906 6.333,1.219 0.615,0.313 10 MB 4.531,0.896 4.99,1.198 0.458,0.302 10 3C 4.583,0.698 4.833,1.042 0.25,0.344 10 9 6.104,0.906 6.552,1.083 0.448,0.177 10 LGCY 1.281,1.052 1.625,1.229 0.344,0.177 10 T3 1.281,1.208 4.156,1.854 2.875,0.646 10 Luggage Compartment Door Lock Assembly 4.333,1.469 5.969,2.01 1.635,0.542 10 Instrument Panel Junction Block Assembly 5.458,2.073 7.125,2.563 1.667,0.49 10 Main Body ECU (Multiplex Network Body ECU) 1.708,0.813 1.969,1.063 0.26,0.25 10 2 1.875,0.813 2.354,1.26 0.479,0.448 10 E 2.99,0.813 3.188,0.99 0.198,0.177 10 3 2.74,0.802 2.958,0.969 0.219,0.167 10 D+

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / Main Body / Data List.


e.

Read the display on the intelligent tester.

Body Electrical > Main Body > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
Luggage Courtesy SW Luggage compartment door courtesy switch signal ON or OFF ON: Luggage compartment door open
OFF: Luggage compartment door closed
-
Body Electrical > Main Body > Data List
Tester Display
Luggage Courtesy SW
50003 123 53
OK:

Normal conditions listed above are displayed.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
2.INSPECT LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY
a.

Remove the luggage compartment door lock assembly.

Click hereVehicle Interior>DOOR LOCK>LUGGAGE COMPARTMENT DOOR LOCK>REMOVAL


b.

Inspect the luggage compartment door lock assembly.

Click hereVehicle Interior>DOOR LOCK>LUGGAGE COMPARTMENT DOOR LOCK>INSPECTION

OK:

Luggage compartment door lock assembly is normal.



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)

NG

REPLACE LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (LUGGAGE COMPARTMENT DOOR LOCK ASSEMBLY - INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY)
a.

Disconnect the 3C instrument panel junction block assembly connector.


b.

Disconnect the T3 luggage compartment door lock assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
T3-3 (D+) - 3C-9 Always Below 1 Ω
T3-3 (D+) - Body ground Always 10 kΩ or higher
T3-2 (E) - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.INSPECT INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
a.

Remove the instrument panel junction block assembly.

Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL


b.

Remove the main body ECU (multiplex network body ECU) from the instrument panel junction block assembly.


c.

Measure the resistance according to the value(s) in the table below.

E173023C17
1.115,0.292 1.427,0.5 0.313,0.208 4.74,0.396 5.052,0.604 0.313,0.208 3.417,1.042 3.573,1.531 false 1.198,0.323 1.458,0.531 0.26,0.208 10 3C 4.792,0.427 5.052,0.635 0.26,0.208 10 MB 3.5,1.552 3.938,1.708 0.438,0.156 10 LGCY 0.125,0.073 0.313,0.26 0.188,0.188 10 *a
*a Component without harness connected
(Instrument Panel Junction Block Assembly)
- -


Standard Resistance:
Tester Connection Condition Specified Condition
3C-9 - MB-4 (LGCY) Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY