Home › Vehicle Exterior › LIGHTING (EXT) › AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) › 2012.02–2015.04
RM2030EQ _59 Vehicle Exterior _014680 LIGHTING (EXT) _0074739 AFS (ADAPTIVE FRONT-LIGHTING SYSTEM) J

LIGHTING (EXT)  AFS (ADAPTIVE FRONT-LIGHTING SYSTEM)  AFS OFF Switch Circuit  


DESCRIPTION

When the headlight swivel main switch is pushed (ON), the AFS ECU (headlight swivel ECU assembly) will cancel the intelligent AFS control and turn on the AFS OFF indicator light.

WIRING DIAGRAM

E220288E01
2.543,1.22 2.642,1.369 0.098,0.149 10 3 3.701,1.223 3.799,1.373 0.098,0.149 10 6 5.431,1.223 5.606,1.373 0.175,0.149 10 32 5.697,1.308 6.062,1.457 0.365,0.149 10 MSW 2.235,1.684 2.408,1.833 0.173,0.149 10 I8 2.235,1.852 4.106,2.203 1.871,0.351 10 Headlight Swivel Main Switch (AFS OFF Switch) 5.483,2.48 5.844,2.63 0.361,0.149 10 A35 5.483,2.648 6.936,2.976 1.453,0.328 10 AFS ECU (Headlight Swivel ECU Assembly)

PROCEDURE

1.READ VALUE USING INTELLIGENT TESTER
a.

Connect the intelligent tester to the DLC3.


b.

Turn the ignition switch to ON.


c.

Turn the intelligent tester on.


d.

Enter the following menus: Body / AFS / Data List.


e.

Read the display on the intelligent tester.

Body Electrical > AFS > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
AFS OFF Switch Headlight swivel main switch signal ON or OFF ON: Headlight swivel main switch pushed
OFF: Headlight swivel main switch not pushed
-
Body Electrical > AFS > Data List
Tester Display
AFS OFF Switch
50003 165 1
OK:

Normal conditions listed above are displayed.



Result:
Proceed to
OK
NG



OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

2.INSPECT HEADLIGHT SWIVEL MAIN SWITCH
2.INSPECT HEADLIGHT SWIVEL MAIN SWITCH
a.

Remove the headlight swivel main switch.

Click hereVehicle Exterior>LIGHTING (EXT)>AFS OFF SWITCH>REMOVAL


b.
E145243C04
0.179,0.149 0.434,0.312 0.255,0.163 10 *a
*a Component without harness connected
(Headlight Swivel Main Switch)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
6 - 3 Not pushed (OFF) 10 kΩ or higher
Pushed (ON) Below 1 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL MAIN SWITCH - AFS ECU)

NG

REPLACE HEADLIGHT SWIVEL MAIN SWITCH

3.CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL MAIN SWITCH - AFS ECU)
a.

Disconnect the A35 AFS ECU (headlight swivel ECU assembly) connector.


b.

Disconnect the I8 headlight swivel main switch connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
A35-32 (MSW) - I8-6 Always Below 1 Ω
A35-32 (MSW) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL MAIN SWITCH - BODY GROUND)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.CHECK HARNESS AND CONNECTOR (HEADLIGHT SWIVEL MAIN SWITCH - BODY GROUND)
a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
I8-3 - Body ground Always Below 1 Ω



Result:
Proceed to
OK
NG



OK

REPLACE AFS ECU (HEADLIGHT SWIVEL ECU ASSEMBLY)

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR