The air conditioning panel (heater control switch board) communicates with the air conditioning amplifier assembly through the LIN communication system.
If the LIN communication system malfunctions, the air conditioning amplifier assembly does not operate even if the air conditioning panel (heater control switch board) is operated.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory |
|---|---|---|---|---|
| B14B2 | Lost Communication with Front Panel LIN | Lost communication with the air conditioning panel (heater control switch board). | ·
Harness and connector between air conditioning panel (heater control switch board) and IG circuit ·
Harness and connector between air conditioning panel (heater control switch board) and body ground ·
LIN communication system ·
Air conditioning panel (heater control switch board) ·
Air conditioning amplifier assembly |
Memorized
(10 sec. or more)*1 |
*1: The air conditioning amplifier assembly stores the DTC of the respective malfunction if it has occurred for the period of time indicated in the brackets.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Disconnect the I56 air conditioning panel (heater control switch board) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I56-2 (IG+) - Body ground | Ignition switch off | Below 1 V |
| I56-2 (IG+) - Body ground | Ignition switch ON | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I56-6 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I77 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I56-9 (LIN1) - I77-37 (LIN1) | Always | Below 1 Ω |
| I56-9 (LIN1) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the air conditioning panel (heater control switch board).
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING PANEL>DISASSEMBLY
Since the air conditioning panel (heater control switch board) cannot be inspected while it is removed from the vehicle, replace the air conditioning panel (heater control switch board) with a new or a known good one and check that the condition returns to normal.
Air conditioning panel (heater control switch board) operation returns to normal.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (When troubleshooting according to Problem Symptoms Table) | B |
| NG (When troubleshooting according to the DTC) | C |
A
B
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PROBLEM SYMPTOMS TABLE
C