1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67913
3.REMOVE FRONT DOOR SCUFF PLATE
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62111A
4.REMOVE COWL SIDE TRIM SUB-ASSEMBLY
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>ROOF HEADLINING>REMOVAL
62311B
5.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP
for LHD: Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
for RHD: Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55317A
6.REMOVE INSTRUMENT SIDE PANEL
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
53921B
7.REMOVE FRONT PANEL GARNISH
Use the same procedure for the RH side and LH side.
Click hereVehicle Interior>INTERIOR PANELS / TRIM>INSTRUMENT PANEL SAFETY PAD>REMOVAL
55607
8.REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
55303B
9.REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY
82877
10.REMOVE ECU INTEGRATION BOX RH (for LHD)
88650N
11.REMOVE AIR CONDITIONING AMPLIFIER ASSEMBLY
Disconnect each connector.
for LHD:
Remove the 2 screws.
Disengage the 2 guides and remove the air conditioning amplifier assembly.
for RHD:
Remove the 2 screws.
Disengage the 2 guides and remove the air conditioning amplifier assembly.