The blower fan with motor sub-assembly is operated by signals from the air conditioning amplifier assembly. Blower motor with fan sub-assembly speed signals are transmitted in accordance with changes in the duty ratio.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Air Conditioner / Active Test.
Check the operation by referring to the table below.
| Tester Display | Measurement Item | Control Range | Diagnostic Note |
|---|---|---|---|
| Blower Motor | Blower motor with fan sub-assembly | Min.: 0, Max.: 31 | - |
| Tester Display |
|---|
| Blower Motor |
Blower motor with fan sub-assembly operates and blower motor speed level changes.
| Result | Proceed to |
|---|---|
| OK | A |
| NG (Blower motor with fan sub-assembly does not operate) | B |
| NG (Blower motor with fan sub-assembly operates but does not change speed) | C |
A
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING SYSTEM>PROBLEM SYMPTOMS TABLE
B
C
Disconnect the I76 blower motor with fan sub-assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I76-1 (GND) - Body ground | Always | Below 1 Ω |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I76-3 (+B) - Body ground | Always | 11 to 14 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the I77 air conditioning amplifier assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I77-22 (BLW) - I76-2 (SI) | Always | Below 1 Ω |
| I77-22 (BLW) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the I76 blower motor with fan sub-assembly connector.
| *a | Front view of wire harness connector
(to Air Conditioning Amplifier Assembly) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| I77-22 (BLW) - Body ground | Always | 4.5 to 5.5 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
| *a | Component with harness connected
(Air Conditioning Amplifier Assembly) |
Remove the air conditioning amplifier assembly.
Click hereVehicle Interior>HEATING / AIR CONDITIONING>AIR CONDITIONING AMPLIFIER>REMOVAL
Reconnect the I77 air conditioning amplifier assembly connector.
Turn the ignition switch to ON.
Turn the blower switch on (LO).
Measure the waveform between terminal I77-22 (BLW) of the air conditioning amplifier assembly and body ground.
Waveform is similar to that shown in the illustration.
The waveform varies with the blower speed.
| Item | Content |
|---|---|
| Tool setting | 1 V/DIV., 500 μs/DIV. |
| Vehicle condition | Ignition switch ON
Blower switch on (LO) |
| Proceed to |
|---|
| OK |
| NG |
OK
NG