Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › PARKING ASSIST MONITOR SYSTEM › 2012.02–2015.04
RM2030EQ _56 Audio / Visual / Telematics _014660 PARK ASSIST / MONITORING _0074557 PARKING ASSIST MONITOR SYSTEM C

PARK ASSIST / MONITORING  PARKING ASSIST MONITOR SYSTEM  C1691  Back Camera Initialization Incomplete  


DESCRIPTION

This DTC is stored when the navigation ECU sub-assembly judges that the back camera initial setting has not been memorized (rear television camera optical axis adjustment is incomplete).

DTC No. Detection Item DTC Detection Condition Trouble Area
C1691 Back Camera Initialization Incomplete Back camera initial setting has not been memorized
·

Rear television camera optical axis adjustment

·

Navigation ECU sub-assembly



CAUTION / NOTICE / HINT

NOTICE:
·

When "System initializing" is displayed on the navigation ECU sub-assembly after disconnecting the cable from the negative (-) battery terminal, correct the steering angle neutral point.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION

·

Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the parking assist monitor system may be needed.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>CALIBRATION



PROCEDURE

1.ADJUST SETTINGS
a.

Perform the following procedure depending on the memory conditions to register the vehicle information into the navigation ECU sub-assembly.

i.


Result:
Proceed to
NEXT



NEXT

2.CHECK DTC OUTPUT
2.CHECK DTC OUTPUT
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Navigation System > Clear DTCs
50002 212

b.

Check for DTCs.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>DTC CHECK / CLEAR

Body Electrical > Navigation System > Trouble Codes
50001 212
Result:
Result Proceed to
DTC C1691 is output A
DTCs are not output B


HINT:
·

If DTC C1691 is output, perform the rear television camera assembly optical axis adjustment again.

·

If DTC C1691 is still output after performing the rear television camera assembly optical axis adjustment 3 times, replace the navigation ECU sub-assembly.





A

B

END