This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the navigation system vehicle customization screen.
The certification ECU (smart key ECU assembly) controls the smart entry and start system (for Entry Function) related items that are customizable via the multi-display screen.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15F7 | Certification ECU Vehicle Information Reading/Writing Process Malfunction | Certification ECU (smart key ECU assembly) vehicle setting processing error. | ·
CAN communication system ·
Smart entry and start system (for Entry Function) ·
Certification ECU (smart key ECU assembly) ·
Navigation ECU sub-assembly |
Use the intelligent tester to check if the CAN communication system is functioning normally.
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
CAN communication DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
Check if the smart entry and start system (for Entry Function) is malfunctioning.
Customization may not be possible depending on the malfunction in the smart entry and start system (for Entry Function).
No malfunctions are present in the smart entry and start system (for Entry Function).
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Display the "Door lock settings" screen.
Make a note of the customizable items for each certification ECU related system.
These items shown as customizable via the navigation system vehicle customization screen can also be changed manually. In a following step, a manual procedure will be used.
Check the customize parameters list for the smart entry and start system (for Entry Function) related items that can be customized via the multi-display screen.
Manually change and confirm that it was possible to successfully change the settings of the customize parameters for each system that are available for customization via the multi-display screen.
The items available for customization via the multi-display screen can be customized successfully using the manual procedure.
| Proceed to |
|---|
| OK |
| NG |
OK
NG